From 526e539628e051128abf46a60ec22e18c9b5d84f Mon Sep 17 00:00:00 2001 From: Benjamin Marzinski Date: Wed, 31 May 2017 15:03:02 -0500 Subject: [PATCH 09/14] multipath: set verbosity to default during config condlog was setting the verbosity to 0 if there was no configuration. This keeps multipath from printing warning messages about config file problems that are found while loading the configuration. Instead, it should use the default config level until it loads the configuration to find the current value. Signed-off-by: Benjamin Marzinski --- libmultipath/debug.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/libmultipath/debug.c b/libmultipath/debug.c index fbe171a..f89b264 100644 --- a/libmultipath/debug.c +++ b/libmultipath/debug.c @@ -11,6 +11,7 @@ #include "../third-party/valgrind/drd.h" #include "vector.h" #include "config.h" +#include "defaults.h" void dlog (int sink, int prio, const char * fmt, ...) { @@ -21,7 +22,7 @@ void dlog (int sink, int prio, const char * fmt, ...) va_start(ap, fmt); conf = get_multipath_config(); ANNOTATE_IGNORE_READS_BEGIN(); - thres = (conf) ? conf->verbosity : 0; + thres = (conf) ? conf->verbosity : DEFAULT_VERBOSITY; ANNOTATE_IGNORE_READS_END(); put_multipath_config(conf); -- 2.8.1